Schneider Conext Configuration Tool FOR RENTAL SEE DESCRIPTION

Description

This Schneider Conext Configuration tool is used to update firmware and make changes to your Conext XW Pro, XW+, and SW system hardware
.
This is for rental period of 14 days. Please contact us to arrange a longer rental period. A fully-refundable 0 deposit is required, which will be fully refunded once returned.
It is listed as a shipping cost, but we assure you that it will be refunded once the tool is returned. Your total out-of-pocket cost of includes shipping both ways.
Use this tool at your own risk. We cannot be held liable for damage to your system as a result of changes made by this device.
The software can be downloaded for free from Schneider's website.
About
The Conext™ Configuration tool is used by system installers to simplify the task of system configuration and reduce installation time. It’s a PC-based software tool that works on systems that include the Conext™ XW Pro, XW+, SW, and peripherals.
The Conext Configuration tool is not meant to replace the Conext™ System Control Panel (SCP), Insight or any other monitoring devices.  Those monitoring devices may still be required to monitor the Conext System and components.
Software and drivers for the Conext Configuration Tool are under the downloads section (Firmware).
Conext Config USB Driver is firmware used for general installation setup.
Conext Config Tool Software_AI (Anti-Islanding) is used when 2 or more inverters are installed in parallel on a single phase connection (See Conext XW+ Multi-Unit Power System Design Guide under the downloads section (Technical Publications). It is also used if there is a specific requirement by a utility.
Note:
Adjustment of AC anti-islanding parameters should only be done after consultation with the power utility or authority having jurisdiction.
Note:
Use either Insight or the configuration tool to complete firmware upgrades – but not both.