Outback Power FM80 FlexMax 80 MPPT 80 Amp Solar Charge Controller

Description

Outback Power Systems
FLEXmax 80
MPPT Charge Controller
The
FLEXmax 80
is the latest innovation in Maximum Power Point Tracking (MPPT)
charge controllers
from OutBack Power Systems. The FLEXmax 80’s innovative MPPT algorithm is both continuous and active, increasing your renewable energy yield up to 30%. Thanks to enhanced cooling, the
FLEXmax 80
can operate at its full 80 amp maximum current rating in ambient temperatures as high as 104°F (40°C).
Included in the FLEXmax 80 are all of the features first developed by OutBack Power in the revolutionary MX60, such as support for a wide range of nominal battery voltages and the ability to step-down a high voltage solar array to recharge a low voltage battery. A built-in backlit display shows status information at the touch of a button. Enhanced network communications allow the FLEXmax 80 to be remotely programmed via the optional MATE system display and controller.
The new FLEXmax 80 is the only choice when you demand a high performance, efficient and customizable charge controller for your advanced power system.
Features:
Increases PV Array Output by up to 30%
Advanced Continuous Maximum Power Point Tracking Algorithm
Full Output Capacity in Ambient Temperatures up to 104°F (40°C)
Battery Voltages from 12 VDC to 60 VDC
Automatic Battery Voltage Detection at Start Up
Fully OutBack Network Integrated and Programmable
Programmable Auxiliary Control Output
Negative or Positive Ground System Capable
Built-in 128 days of Data Logging
FLEXmax™ 80 Specifications*
Nominal Battery Voltages
12, 24, 36, 48, or 60 VDC (Single model - selectable via field programming at start-up)
Maximum Output Current
80 amps @ 104° F (40°C) with adjustable current limit
Maximum Solar Array STC Nameplate
12 VDC systems 1250 Watts / 24 VDC systems 2500 Watts / 48 VDC systems 5000 Watts / 60 VDC Systems 7500 Watts
NEC Recommended Solar Array STC Nameplate
12 VDC systems 1000 Watts / 24 VDC systems 2000 Watts / 48 VDC systems 4000 Watts / 60 VDC Systems 5000 Watts
PV Open Circuit Voltage (VOC)
150 VDC absolute maximum coldest conditions / 145 VDC start-up and operating maximum
Standby Power Consumption
Less than 1 Watt typical
Power Conversion Efficiency
97.5% @ 80 Amps in a 48 VDC System - Typical
Charging Regulation
Five Stages: Bulk, Absorption, Float, Silent and Equalization
Voltage Regulation Set points
10 to 80 VDC user adjustable with password protection
Equalization Charging
Programmable Voltage Setpoint and Duration - Automatic Termination when completed
Battery Temperature Compensation
Automatic with optional RTS installed / 5.0 mV per °C per 2V battery cell
Voltage Step-Down Capability
Can charge a lower voltage battery from a higher voltage PV array - Max 150 VDC input
Programmable Auxilary Control Output
12 VDC output signal which can be programmed for different control applications (Maximum of 0.2 amps DC)
Status Display
3.1" (8 cm) backlit LCD screen - 4 lines with 80 alphanumeric characters total
Remote Display and Controller
Optional Mate or Mate2 with RS232 Serial Communications Port
Network Cabeling
Proprietary network system using RJ 45 Modular Connectors with CAT 5e Cable (8 wires)
Data Logging
Last 128 days of Operation - Amp Hours, Watt Hours, Time in Float , Peak Watts, Amps, Solar Array Voltage, Max Battery Voltage Min Battery Voltage and Absorb for each day along with total Accumulated Amp Hours, and kW Hours of production
Hydro Turbine Applications
Consult factory for approved Turbines
Positive Ground Applications
Requires two Pole Breakers for switching both positive and Negative Conductors on both Solar Array and Battery Connections (HUB-4 and HUB-10 can not be used for use in positive ground applications)
Operating Temperature Range
Minimum -40° to maximum 60° C (Power capacity of the controller is automatically derated when operated above 40° C)
Environmental Rating
Indoor Type 1
Physical Specifications
Conduit Knockouts
One 1" (35mm)on the back; One1" (35mm) on the left side; Two 1" (35mm) on the bottom
Warranty
Standard 5 year
Weight
- Unit, 12.20 lbs (5.56 kg)
- Shipping, 15.75 lbs (7.10 kg)
Dimensions
- Unit 16.25" x 5.75" x 4" (41.3 x 14 x 10 cm) - (H x W x D)
- Shipping 21" x 10.5" x 9.75" (53 x 27 x 25 cm)
Options
Remote Temperature Sensor (RTS), HUB 4, HUB 10, MATE, MATE 2
Menu Languages
English & Spanish
OutBack Power provides a five (5) year limited warranty against defects in materials and workmanship, and a two (2) year limited warranty against fan failure