11.3 Control Board LF Split Phase Pure Sine Wave Power Inverter DC 24V PowerJack

Description

11.3 version control board
for Power Jack & U Power LF SP pure sine wave power inverter
DC 24V to AC110V&220V
Note
1.this is only suitable for your control board is 11.3 version, if your orginal control board are 7.0v/8.0v/9.0v/10.3v/11.0v (the part no. can refer the up right side of the control board),you need to take clear photos to show your orginal control board's version for our ref,then we can add suitable wire to connect to use,tks.
2.when you repair the inverter, you must be replace the control board & power mos board at the same time,because when inverter dead, usually 1-2 power mos board burned+ driver board on the control board,if you only replace one of them, its probably you may damage one of the good parts.after replaced the power mos board, you need check if have shorted situations on the main board,you can contact us to get the link show you how to test.
3. after replace the 11.3 control board, pls recheck again all cable will be the right position.
4. if you still have any other issue need us offer, pls just feel your free to contact with us.
From above, the parts can make your inverter back again, but this not including you replace the wrong way, transfromer already shorted(can refer youtube how to check transformer, but usually transformer is good, thats up to you want check or not), the solutions can solve 95% defetitive, not 100% gurrantte can be replaced, if you fail to done it, the parts can not be accepted return, pls make sure this can be accept before you buy, but we hople & will help you to make it back again, so the better way just has little issue, asking us before the next step, tks.